@mylesj One more thing... your batteries are NOT at 55% SOC or anywhere close to it. They are near dead. 47.6V is less than 10% SOC. This is related...

@joel-brodeur Hello and yes there was a system reboot after the settings change. I have also lost my power now. And I connected the inverter to my ...

@jlankford Hello and yes there was a system reboot after the settings change. I have also lost my power now. And I connected the inverter to my tran...

@joel-brodeur I looked at the manual... it appears that function is just incorporated into the single "AC Charge Based On" setting for the 6000. ...

@jlankford On the 6000 the "AC Charge Enable" is not an option. I am assuming that since there is no sell back that the option is always on. (just an...

@joel-brodeur On the 18Kpv, there is a setting "AC Charge Enable" which I do not see in the above screen shots. Is that not a setting applicable to...

@pawnee Glad the update fixed the Gen run, did it also fix the Watt readings? Hopefully @eric has some news or suggestions on the hard handover. J...

@mylesj I am guessing you can't disable it. Maybe just set your gen start SOC to something like 20%. Also, if you haven't already, you might try, r...

@joel-brodeur Hello Joel, I tried you suggestions and it did not work. I have tried to disable the generator setting and it wont allow me to do it...

@joel-brodeur Hello Joel, I tried you suggestions and it did not work. I have tried to disable the generator setting and it wont allow me to do i...

So getting the firmware completely pushed through got my generator running like it was before, but I’m still getting a browout/hard handover. Bad enou...

One other question - what firmware are you at? JB

@mylesj I notice that you have the Gen settings also set. Are you using a gen to charge as well? If not you might try disabling the gen charge setti...

@joel-brodeur Thank you Joel! I just tried your suggestion. Still nothing. I hit the quick charge button again and it says its charging but it is n...