Are you running closed loop comm? What is the value of the BMS Limit Charge parameter that the master battery is sending to the inverter?  

Your panel and meter base setup sounds exactly like mine, 2-200 amp panels and 1-400 amp base. But, my house doesn’t require 400amps, not even close, ...

I have a similar issue, my unit blows cold AC but no heat, I did the testing that was asked for and submitted it with an RMA request 3 weeks ago as re...

Don't believe I'm entirely off topic, but I was searching for solutions for cleaner generator switching with my Gridboss / Flexboss21 on the forum and...

I just received a 12000xp , box is pretty beat up ! Is there a way to test the inverter before I mount it to the wall ? (I only have 120 volt power ...

Thanks, updated to version 0507

I think i can figure this out now. I see i can add the dongles.

@eg4eric Okay it worked this time. Do i need set up the second dongle the same way to see the paralell inverter status?

Good afternoon, So, you were able to register the dongle, but you just don't see the network of the dongle?

@t345 You can find the changelog in the EG4 Monitor Website, by going to Maintenance, clicking on the question mark next to the current firmware your ...

@eg4eric YES, ONLY from Grid. No Solar connected. Been having several issues since newest firmware was installed. This is the one that is straightfor...

Is it charging the batteries from grid?

@eg4eric great, thank you!