EG4 Community Forum

Anonymous
Joined: April 9, 2026 5:41 pm
Topics: 6 / Replies: 19
Reply
RE: Help! 18Kpv suddenly went offline

@CaesarV You might check out the following doc: EG4-Dongle-Recovery-Guide.pdf or: EG4-Wifi-Dongle-Troubleshooting-Guide.pdf Thanks, JB

1 year ago
Topic
Replies: 9
Views: 2510
Reply
RE: 6000xp bug in charge controller setpoint voltages with open loop

system reverted to "bad behavior" for some reason.... floating at charge voltage ?! really, really, really NOT what I want. When can we expect to see ...

1 year ago
Forum
Reply
RE: 6000xp load side voltage

@nolensb , wow, that's a big miss on mfg QC ! but, not same problem in my case.....

1 year ago
Forum
Reply
RE: Tigo integration not updating live data on EG4 monitoring site

@joel-brodeur Thanks JB. I have noticed Tigo systems have occasional extended delays updating sometimes-so your experience continues.

1 year ago
Reply
RE: Tigo integration not updating live data on EG4 monitoring site

I had the same issue when I first set mine up. then after a day or so it started to work as expected. One thing I did notice was that the three "Sol...

1 year ago
Reply
RE: 6000xp Load voltage

The resolution for this issue has been shared in this thread.

1 year ago
Forum
Reply
RE: 18kPV will charge LifePower4 batteries but will not pull from them.

Is Power Backup enabled? If so, could you export your settings and share them in this thread?

1 year ago
Reply
RE: WTF?! finished install of a brand new 6000xp, Display shows "all good", but no voltage at Load AC breaker ?!

@jared , I will drive up later today.... it's about an hour into the woods...

1 year ago
Forum
Reply
RE: Important Update: LCD Version 18 Firmware

@donbarber this has been reported, and we are actively looking into having this corrected.

1 year ago
Reply
RE: Flexboss setting to enable MID

Could you please DM me the serial number for the FlexBOSS21 so I can take a look? Additionally, you should be able to use the local monitoring feature...

1 year ago
Reply
1 year ago
Forum
Reply
RE: 6000XP Generator Charging

@johnnyg Is the neutral bonded in the new house panel? Is the inverter also neutral bonded? If yes to both, you created a loop.

1 year ago
Reply
RE: 6000XP Generator Charging

After heating up the trailer and batteries they started accepting generator charging. I will be checking into the Hz rate coming from the generator to...

1 year ago
Page 340 / 387