@eric is there a ModBus input-address associated with the "Grid Sell Back Power" setting? It really sucks that the Grid Sell Back Power setting...

I have almost the same setup and for the same reasons. I struggled with settings until I bought Solar Assistant on the Raspberry PI. What i did was au...

H Eric, Thank you again for the help! I tried different protocols and it seems that only open loop works when only the battery is connected. B...

@eric Signature Solar said would replace but that’s not possible as I’m in the Caribbean, Dominican Republic and not an option to ship back. Said n...

@eric Thanks for the quick response! Can you provide some reasons for the incompatibility? Also, would the addition of a string optimizer allow the ...

@chill633 Where are you finding the UL 9540 certificates? I have been searching and scouring and cannot find them. All I find is the UL 9540A testing ...

A wind turbine cannot be connected directly to the inverter. You can use a wind turbine to charge the batteries, but this requires a separate charge c...

Try logging out of his phone, logging into your device first, and then logging back into his. We've tested this multiple times, and it does allow the ...

I had the wrong EG four app. Looks like everything is working fine now thanks for your initial reply. I appreciate it and what about that free upgrade...

@eric That is correct about the application the E G4 app. My cousin set up and logged in and when I use his credentials username/password it does not ...

Do you know if the inverter is reading 100Ah?If so, you can check setting #6 (Charging amperage) and make sure that it is set to between 50A-100A (20A...

@eric Thanks for the response. I do not know the modes used at set up , that is the problem , it was done by a technicial that know little about this ...

@joel-brodeur There is a changelog for the RS232 update, but not for the RS485. You can update both, but you will not see the RS232 update unless you ...