@pawnee I'll report this issue to our team so we can look into it. Just to make sure you are using the EG4 monitoring app not the new EG4 connect app,...

  Yes, I’ve done it multiple times on my 18k’s just won’t work on the 12 or 6xp. Pretty sure it’s a App problem  

@eg4eric I have the same issue I Grid Boss and Flexboss21 to a new wall battery and generator plug- added to my Solar Edge PV system. But never see t...

Hey, moving the V2(no dip switches) to the master battery position worked like a charm: 9 batteries/900 amps shown! However, in an interesting twist...

I just installed a very similar architecture. I have a 400 amp split SE with two 200A breakers immediately after the meter, all combined in the SE pan...

@dtbaker61 I definitely don't want 3 or 4 hours at that voltage to be sure. I've spoken with the SimpliPHI tech over the past 4 years with these batt...

@ouijifour thank you for sharing. I'll start reading to try to figure it out. Strangely, today after switching my settings back to FLA lead acid, my...

@dtbaker61 That cycling from float to bulk back to float is exactly why I quit using the eg4 xp6000 for charging lithium batteries. There are a lot be...

@dtbaker61 you may want absorb time to give the bms time to balance the cells . They only will do that at the top of the charge cycle. It really depen...

looks like update to ccaa-1c1212 fixes this for the 6000xp. see details and notes:/p>

I'm following up on the best available fix for the 6000xp open loop charge control.... which is to do a firmware update to version ccaa-1c1212 which i...

@mtjag you do NOT need or want any absorb time with Lithium batteries

@eg4eric Thanks, I'll give it a try and let you know if that clears it up. Scott

@eric, Interesting little experiment. I've exported data for Oct 2025 - Feb 2026 ( through today). I then dropped it into an AI and had it analyze. ...