I turned the EPS switch on, the update went through but is still not showing the new version? does it take time to update once it says it is updated?

@joel-brodeur It was just a simple fix! Charge ahead!

@joel-brodeur @eric @jlankford Okay! Problem solved! The solution is a simple one. In order for the AC to charge the EPS switch needs to be ...

Okay! Problem solved! The solution is a simple one. In order for the AC to charge the EPS switch needs to be in the ON position with the load break...

@eric @joel-brodeur Thank you for the continued feedback! It is very helpful. I did sent a note to my electrician about adding the safeguard to...

The system is set up by a certified electrician with all of the safety precautions in mind. I thought I did turn the ac in breaker off. I can try th...

It is a 30amp inlet receptacle for a 30amp generator cord.

Hello, Included a main panel image showing wires to the 50amp transfer switch breaker. And there is another 30amp transfer switch located outside, t...

Hello Eric, thank you! I had a certified electrician install an am assuming it was properly wired. I took a pic of the inverter wires and the main pa...

@jlankford Hello Joel. I know the EG4 chargeverter is the top suggestion for charging but will the BigBattery charger I have attached work as well?...

@joel-brodeur I will post the info when I get a minute. And yes. The grid is to charge the batteries only. I worked with Shop Solar Kit sales on th...

@jlankford I will do that! I ordered an inexpensive clamp ac/dc voltage meter so I can confirm voltage as needed. Another tool in the toolbox!

@jlankford Thank you for your help! I am going to work with the EG4 support team on this. The SSK sales support said I could do this set up with an A...

@jlankford Thank you! I shut it down for now until I get the batteries charged up. I put in a support request also to get some additional direction...