@caesarv that's pretty much my take on it too. The old/current app shows you pretty much all the data with the exception of accumulating ac-coupling ...

I wish I had seen this post prior to updating my batteries... Same issue as described. I upgraded both RS485 and RS232 firmwares to Z02T28 & S02T2...

@cshurtz the EG4 suggestion(s) was to revert to lead-acid mode (not an option for our client). it is unclear if that helps to see the data for all bat...

@samjam24x7 Can you share a screenshot of what you're seeing?I would like to confirm it's not the app. If it's an issue with the app, sending another ...

@bobandroslyn I don't believe it's supposed to provide a confirmation, but it would be a good idea for them to send one. I will mention this as well. ...

@gigadude I would have to double check if we can send a replacement board or if the whole inverter would need to be replaced. Have you tested voltage ...

Why don't you just remove the wifi config (SSID and passkey),from the donglemso you are sure it cannot connect to wifi? I'd rather be sure as opposed ...

  I'm not sure I'd anyone actually tested my scenario. It's important that someone at eg4 tests it Even if I disable my cellular network the ...

Also - Should the dongle auto switch from WIFI to Ethernet if WIFI is lost?

I had done both as you suggested prior to this initial post. Doing again now to log response. 1. Unplugged the dongle and connected it again. LED's ...

The same thing happened to me after just upgrading firmware on my 3 indoor 280ah batteries. Have you figured out anything yet? I can only read one bat...

@caseysweb I just updated my 3 indoor 280ah batteries with the latest firmware and now I can only read the master battery. What did you do to resolve...

Are you communicating both batteries with the inverter? Usually, the batteries can either communicate with the inverter or the chargeverter. you will ...