@ponobillYou can use your phone and update the inverter through our EG4 app.

@caseysweb On the Flexboss, you can change the battery type to Lead Acid and set all the voltage parameters.

@james You can find it here ↓Indoor Wallmount – EG4 Community Forum

sounds like a real load.... 6-7kw would definitely show a little corresponding voltage sag. The heater in the wallmount (280ah) battery is a few hundr...

I believe I have discovered my mystery load. I installed a new high efficiency water heater last year. It has a 24.1amp load when it goes into heati...

Another load spike is happening right now. Inverter fans are running. The load jumped up to 6676W according to the monitoring app.

Station name is Anderson Solar and the Serial number is 5400E0146. The last event happened at 2 in the morning, we were in bed sleeping, but I have ...

@lucilightningIf you send me your information, I can make sure one of our team members contacts you as soon as possible.

@lucilightning Is your inverter running the lates firmware?

@fkitzmannCan you disconnect the dongle and connect it again? It should display the blinking IP LED on the dongle. You can also hold the reset button ...

@johnaandAre you able to share your station name or inverter's serial number with me so I can look into this issue for you?Do you notice the power goi...

@clarktheshark I'm glad you were able to get it resolved!Also, I'm taking notes on this in case it comes up again.

@eg4eric - Thanks for helping out. I haven't seen any failures in a few weeks. That being said, I don't really know what fixed it. I think I may have ...