@pawnee Which firmware version is installed on the LifePower4 V2? In my opinion, 0% would not be 47v. However, it would be very close.

Direct message sent. No codes were thrown.

@dlwittsr If the CAN protocol is set to EG4/LUX, the BMS communication will remain active. I’d suggest switching the RS485 protocol on the master batt...

Were there any error codes reported with this? Also, if you are able to DM the serial number for the inverter, I can take a look at it on the monitori...

We are still investigating the bug not allowing the 6000XP to equalize while in lead-acid. However, this solution from another thread may work as a qu...

The best solution would be to run the PV ground to the earth ground installed at the home grounding rod.

@simply-efficient I've wondered where they pull the SoC they show for the inverter when there are multiple batteries. I used to use the test app to s...

@jared my Lifepower4 V1’s and V2’s do communicate with the 18k but the SOC on all 6 shows 0% at 47 volts. Is this right? I’m just doing what the Tec g...

@umar I do not have documentation that covers this. However, I will be updating this thread as soon as I receive an answer.

Yes - the RS485 proto is set to the 1st item - EG4. What is a 'separate protocol', and would not a change to the RS485 protocol break the inverter t...

Page 33 of the manual has a few details going over each button on the remote control.

The firmware update is not needed, but there are improvements to the cycle count logic.That is the correct cable for the RS232 update. The RS232 is re...