so does your inverter see your batteries with just the .hex update?

I was told today that the RS485 bin file is the update for the battery screen so I am not going to worry about it until I get my laptop hooked up.

Gen stopped brood low frequency. Stated back up after I reset it and it’s charging the batteries. WTH

So I still haven’t bought a chargeverter. Tonight the generator kicked on but won’t charge the batteries. It ran a couple days ago and worked perfectl...

UPDATE 😓 I have been running on Lead Acid for last week did two full cycles of deep discharging down to 0% and then charging to 100%.Today ...

Battery Type: 2: Lithium Lithium Brand: 0: EG4

I am having the same issue with the adapter. I get a fault when trying to update the 485. I deleted the files on the adater and loaded them again with...

@jared Since the LuxPower battery protocol included battery voltage, amperage, temp, max/min cell V. , cell Temperature, and battery capacity should ...

@eg4eric Thank you for checking it! So I presume there isn't a reason that the battery specs have a lower limit for charging Amps?

Nice work! You might take a look at Python Protocol Gateway() to see if there's anything missing in your implementation. I'm using PPG with my EG4 18...

I checked with our technician, and they confirmed that charging below 60A will not cause any battery cell imbalance.

This is based on my research, but I’ll reach out to our battery technician to get a definitive answer.

What do you have set for Lithium Brand?

At this time, the best option would be to replace the entire unit. You can try reaching out to your distributor to see if they have any spare parts av...