@brokenpointjoe it should have worked at those low amps. And FYI on the 18k screen on the generator charge it says Amps but it’s Amps dc. I had my ...

@ron My generator like most does produce dirty power. I use Line and Load reactors on 30-40 VFD’s here the farm. I’ve been thinking about putting ...

I’m not familiar with the wall mount batteries. All the settings you are talking about are programmed in my inverter. I believe most BMS’s look at vol...

@talk2dang My best guess is a bad dongle. My 18k dongle would kick me off the app every couple minutes. After 6 months I finally ask the SS folks t...

I can’t help but think the protocol switches on the V2’s would make a difference

@kw5kw very good. Thanks

I had the same problems and more when adding V2's to my V1's. V2's will have to be on first in the rack to communicate properly. You will also most li...

In case anyone has the same problem I just realized I accidentally post the results of the LCD update on my generator thread. The update fixed the scr...

@joel-brodeur thanks

@eric will do as soon as I figure that out. Never sent a PM

@joel-brodeur yes they used to be displayed on the old version as 2500 or what ever was being pulled. Now the say 2.5 Kw so that’s fine by me. Bett...

@eric 9 Life power V2’s 900 amp hours. 8000 PV watts

So getting the firmware completely pushed through got my generator running like it was before, but I’m still getting a browout/hard handover. Bad enou...

@joel-brodeur It’s a Milbank 15K made by Briggs. It’s a bit different than most. It’s a two wire start but it must not see 240 volts to run. I have...