EG4 Community Forum

Ravasunpower
Ravasunpower
@ravasunpower
Trusted Member
Joined: May 5, 2025 2:20 pm
Last seen: December 30, 2025 4:59 pm
Topics: 8 / Replies: 50
Reply
RE: XP 6000 keeps shutting down…

I am confusing posts and messages , i think… anyway, if you have not read the other message, i changed the inverter and all is well EXCEPT the dispari...

8 months ago
Reply
RE: XP 6000 keeps shutting down…

But thanks for your input, i will contact Eric again. He said he would connect to my system and check but i have not heard from him and i do not know ...

8 months ago
Reply
RE: XP 6000 keeps shutting down…

When it happens, it definitely says warning 25 with a flat face. it also restarts without my input. I did a few shut downs and restarts: when it re...

8 months ago
Reply
RE: XP 6000 keeps shutting down…

@joel-brodeur . Thanks… it has been on and off for the last 3 hours. The inverter shows the green flashing warning with #25 and i thought this meant a...

8 months ago
Topic
Replies: 12
Views: 1471
Reply
RE: Error code 25, 27 on XP6000

Eric, i have to leave the house for a few hours. I am leaving the generator on the internet system so you should have access even if the system goes d...

8 months ago
Forum
Reply
RE: Error code 25, 27 on XP6000

I also noticed that on the monitor page, under the battery it was indicating “BMS charge Forbidden”. Now it is allowed…

8 months ago
Forum
Reply
RE: Error code 25, 27 on XP6000

System just went down again. I have the internet on the generator.

8 months ago
Forum
Reply
RE: Error code 25, 27 on XP6000

Eric, i just stopped the gen as the system came back online… it seems to come back when the first light comes on… coincidence?

8 months ago
Forum
Reply
RE: Error code 25, 27 on XP6000

Good morning Eric, the system went down again during the night. Warning 25 again. I borrowed a generator but it is not on the system directly: i just ...

8 months ago
Forum
Reply
RE: Error code 25, 27 on XP6000

@eric i went into the monitor.eg4electronics.com and i am a bit overwhelmed… so, yes, i would really appreciate if you could change the parameters ...

8 months ago
Forum
Reply
RE: Error code 25, 27 on XP6000

Thank you Eric for the fast answer! i just checked all connections, which were tight. Batteries with multitester indicate the same as the monitor an...

8 months ago
Forum
Topic
Forum
Replies: 15
Views: 1470
Page 4 / 4