EG4 Community Forum

Ron
Ron
@ron
Estimable Member
Joined: October 17, 2024 4:06 pm
Last seen: November 6, 2025 1:35 am
Topics: 14 / Replies: 78
Reply
RE: Hybrid Offgrid Setup Questions

What do you have for HVAC, dryer, water heater, stove and oven, out buildings, well pumps. Anything else that draws a lot of power. 240V stuff? I'm ...

12 months ago
Reply
RE: 6000XP no solar, used as backup generator only, AC Charge will not work

Oops, I didn't see he landed AC output from inverter into main panel

12 months ago
Reply
RE: 6000XP no solar, used as backup generator only, AC Charge will not work

@joel-brodeur I'm not aware of any instance of the 6000xp being able to back feed the grid through the AC input.

12 months ago
Reply
RE: Another Generator question

@zeppelin I've had zero issues, but have only charged the batteries with the chargeverter a few times during grid outages.

12 months ago
Forum
Reply
RE: Enough Batteries or Incorrect Setup

About 11500-12000 watts of useable battery which is still 20 hours

1 year ago
Reply
RE: Another Generator question

Seems like so many issues using the Inverter generator connection, I just use the chargeverter. No issues and charges on voltage so balances out SOC

1 year ago
Forum
Reply
RE: Maximizing Battery Lifespan: Best State of Charge (SOC) Practices

@joel-brodeur I'm thinking that is the best solution. Drop the grid/pv and drain to 20% once a month, but would like to have confirmed by EG4. We ha...

1 year ago
Forum
Reply
RE: Maximizing Battery Lifespan: Best State of Charge (SOC) Practices

With the solar I have available in the summer i'll probably only be able to produce 20% capacity of my batteries daily and way less in the winter. Tha...

1 year ago
Forum
Reply
RE: SOC % setting 11

DOD shouldn't be any lower than 50% and I'd recommend 60% for longevity of the battery. The reason it lasted longer prior to setting it to 50% is befo...

1 year ago
Forum
Reply
RE: BMS not correct in detecting capacity

I'm still using SOC and I initiated a manual charge with the 6000xp for 2 ea. wall mounts. The inverter was only showing 55.9 volts at 100% and then s...

1 year ago
Forum
Reply
RE: BMS not correct in detecting capacity

I thought EG4 recommended 56.2

1 year ago
Forum
Reply
RE: BMS not correct in detecting capacity

What are the voltage settings everyone is using when utilizing voltage instead of SOC for the indoor wall mount batteries

1 year ago
Forum
Reply
RE: 6000XP grid usage

Have you looked to see if you are going over the output capacity

1 year ago
Forum
Reply
RE: Excess Solar Power

Pump water to a higher elevation with excess power and then hydro, unless of course freezing temps

1 year ago
Forum
Reply
RE: AC BYPASS

Seems strange for a washing machine. What is the wattage at when turning it on?

1 year ago
Forum
Page 3 / 7