Yes, I’ve done it multiple times on my 18k’s just won’t work on the 12 or 6xp. Pretty sure it’s a App problem  

@eg4eric I have the same issue I Grid Boss and Flexboss21 to a new wall battery and generator plug- added to my Solar Edge PV system. But never see t...

Hey, moving the V2(no dip switches) to the master battery position worked like a charm: 9 batteries/900 amps shown! However, in an interesting twist...

I just installed a very similar architecture. I have a 400 amp split SE with two 200A breakers immediately after the meter, all combined in the SE pan...

@dtbaker61 I definitely don't want 3 or 4 hours at that voltage to be sure. I've spoken with the SimpliPHI tech over the past 4 years with these batt...

@ouijifour thank you for sharing. I'll start reading to try to figure it out. Strangely, today after switching my settings back to FLA lead acid, my...

@dtbaker61 That cycling from float to bulk back to float is exactly why I quit using the eg4 xp6000 for charging lithium batteries. There are a lot be...

@dtbaker61 you may want absorb time to give the bms time to balance the cells . They only will do that at the top of the charge cycle. It really depen...

looks like update to ccaa-1c1212 fixes this for the 6000xp. see details and notes:/p>

I'm following up on the best available fix for the 6000xp open loop charge control.... which is to do a firmware update to version ccaa-1c1212 which i...

@mtjag you do NOT need or want any absorb time with Lithium batteries

@eg4eric Thanks, I'll give it a try and let you know if that clears it up. Scott

@eric, Interesting little experiment. I've exported data for Oct 2025 - Feb 2026 ( through today). I then dropped it into an AI and had it analyze. ...

I was able to script out an export that pulls a sheet for each day in a range. That works, but it'd be great if we could just export all data for a ...