True 240V. With multiple inverters make sure all L1's and L2's are on opposite sides of the Grid panel

Adding to the mix, I set the system to "Charge battery last" and the problem was gone. I also disconnected the Grid, and the problem was still there, ...

Hi @eric, can you address my question which is still pending as needs "Approval"?

Are you able to run quick charge again so we can monitor the system while the charging is happening, and we can look at the settings to see what exact...

I was able to look at your settings and it looks like you have the Charge Last setting enabled. This would cause the inverter to sell back to grid and...

You would connect the CTs on Line 1 and Line 2 between your meter and service panel with the arrows pointing towards the inverter and you would plug i...

Also note, the issue is recurring.

See attached notes...

Call Signature Solar and they will help you out

One last question. In self-consumption mode with solar, when there is excess power generated and the battery is full - does the extra go to the utilit...

@eric So this would be using Force Discharge instead of Peak Shaving?

I might have it. I had a mode DIABLED but had left the time set from 00:00 to 22:00. When I set both too 00:00 self consumption started.