@coolcat I've attached a document for the Flexboss and Indoor WallMount battery. Let me know if this isn't what you are looking for. EG4-FlexBOSS21-28...

For user-defined, it really depends on your battery's recommended configurations. Normally for EG4 batteries, the settings would be: #26 (Bulk char...

@eg4c I would need to review additional data, as it's difficult to analyze based on a single recorded instance from the inverter.

@jp86gt There is not one for the WallMount batteries. If you need assistance with the firmware updating process, I'd be more than happy to help.

@whiskyneat305 The inverter's MPPTs are engineered solely for solar applications and are not compatible with wind energy. Under no circumstances shoul...

@haitises Unfortunately, we are currently unable to send out the BMS, as our compliance and legal team is still working on the necessary documentation...

For what it's worth, and you're likely aware, but there's a *whole* bunch of people with this problem in the diysolar forum:br />

I'm glad you were able to get it to work! Let me know if you run into other issues.

Also, a related side-question: Does the 6000XP care about and interpret the cell voltage and cell temp values from the pylontech RS485 protocol? IT pa...

SOLUTION: @eric, never mind I believe I found it as ModBus address 103, MaxBackFlow set as a percentage of something. Im not sure what the percentag...

To update this: The homeowner experienced a power outage yesterday (about 5 days after most recent troubleshooting trip) and the system worked exact...

@eric is there a ModBus input-address associated with the "Grid Sell Back Power" setting? It really sucks that the Grid Sell Back Power setting...

I have almost the same setup and for the same reasons. I struggled with settings until I bought Solar Assistant on the Raspberry PI. What i did was au...