Also - Should the dongle auto switch from WIFI to Ethernet if WIFI is lost?

I had done both as you suggested prior to this initial post. Doing again now to log response. 1. Unplugged the dongle and connected it again. LED's ...

The same thing happened to me after just upgrading firmware on my 3 indoor 280ah batteries. Have you figured out anything yet? I can only read one bat...

@caseysweb I just updated my 3 indoor 280ah batteries with the latest firmware and now I can only read the master battery. What did you do to resolve...

Are you communicating both batteries with the inverter? Usually, the batteries can either communicate with the inverter or the chargeverter. you will ...

@ponobillYou can use your phone and update the inverter through our EG4 app.

@caseysweb On the Flexboss, you can change the battery type to Lead Acid and set all the voltage parameters.

@james You can find it here ↓Indoor Wallmount – EG4 Community Forum

sounds like a real load.... 6-7kw would definitely show a little corresponding voltage sag. The heater in the wallmount (280ah) battery is a few hundr...

I believe I have discovered my mystery load. I installed a new high efficiency water heater last year. It has a 24.1amp load when it goes into heati...

Another load spike is happening right now. Inverter fans are running. The load jumped up to 6676W according to the monitoring app.

Station name is Anderson Solar and the Serial number is 5400E0146. The last event happened at 2 in the morning, we were in bed sleeping, but I have ...

@lucilightningIf you send me your information, I can make sure one of our team members contacts you as soon as possible.

@lucilightning Is your inverter running the lates firmware?

@fkitzmannCan you disconnect the dongle and connect it again? It should display the blinking IP LED on the dongle. You can also hold the reset button ...