Eric, i just stopped the gen as the system came back online… it seems to come back when the first light comes on… coincidence?

Good morning Eric, the system went down again during the night. Warning 25 again. I borrowed a generator but it is not on the system directly: i just ...

Thanks @joel-brodeur and @pawnee. I don't understand how an off-grid inverter can be so bad at gen switching functions but it's almost unusable in i...

I would like to understand why it keeps failing, so I can do it correctly. I'm finishing a new install tomorrow and will try again with the inverter ...

That's the thing. I don't see these batteries on any product list. So I'm guessing you are saying that the firmware on the page for the battery SKU:...

@thomaspugmail-com Not at the moment, but as soon as we do, it will be posted on our website. I know that the LCD V18 firmware adds the Gridboss optio...

I understand and I'm happy to help! (We do have a guide that explains the website.)EG4-Monitor-Center-Overview.pdfI just need either your inverter's s...

I'm glad you were able to figure it out and I apologize for any confusion or inconvenience this may have caused. Thank you for the feedback. I’ll pass...

Since the 6000XP is an off-grid inverter, it primarily depends on PV and battery sources to power loads. However, you can configure the settings to al...

@eric i went into the monitor.eg4electronics.com and i am a bit overwhelmed… so, yes, i would really appreciate if you could change the parameters ...

As you mentioned, this configuration is not recommended as these batteries were not made to work together in series. To ensure system stability and av...

Do the batteries have 4 DIP switches? I've attached a document that shows how to tell the difference between the 6-DIP and the 4-DIP switch batteries....

Understood!If you provide your station name or serial number, I can update the LCD firmware remotely on my end.

It turns out the original version of firmware would allow the PV to work even if I have a batt comm failure. To resolve the issue, I used the advance...