finally..... Here are the steps I had to use, after creating a unique email account for this site download/install SmartESS App to phoneplug PowerPl...

@eg4eric , AHA! so this is a big problem for someone like me who is actually an installer and would like to look at multiple units at different physic...

@eg4eric I finally got the dongle to connect w the home wifi,,,,, BUT, now I cannot "add device" to my pre-existing SmartESS account. I had installe...

@eg4eric tried that.... the app seems to look for the PlugPro-05 with BT, and never finds it, so I am stuck with no way to teach the dongle what the h...

something is wrong again. I just installed another 3000, and CANNOT get the dongle configured. - I have updated to SmartESS app v3.40.1.0 - I can...

got it running.... portable power in a 63gal toolbox: 10kwhr-eg4.3k 120v AC inlet for charging from grid PV input for charging from PV AC out ...

{solved} turns out that the paper manual v 1.3.0 was terrible, but the online v 1.3.2 is better, and I was able to get wi-fi monitoring working. ...

the battery BMS is trying to protect itself from over voltage. your setpoints are too high. read thru your battery manual carefully to see what recomm...

@ouijifour setting 100% at 55.2 will cause problems because you are never getting to the point where the voltage curve is steep enough to be accurate ...

@ouijifour , you want to use the absorb = 56.2 , not 55.2 .... it is important to get EOC high enough to reset BMS to 100% and balance. firmware o...

@ouijifour , if you can get the BMS communicating correctly between battery and inverter, you can use 'lithium' and manage setpoints by % since the ba...

@ouijifour , version= ccaa-190D0E seems to be "fairly good" most of the time. I see a CC/CV charge curve "as programmed" most of the time, but have no...

these settings are working pretty well with 6000xp firmware v 190D0E. Most days I see a correct battery voltage cc-cv curve with end-of-charge at 56.2...