@eg4eric thanks Eric, I do have another major issue/question/bug that probably needs to get to Engineering and handled as a firmware update. I started...

@eg4eric thanks, I am in contact with Callie in CustomerOutreach.... I think making progress.

@eg4eric The Seller (offgridsource.com) is giving me a total runaround. First requesting videos, then still photos, then the serial number, and then ...

@krzysiek_kta it is not great for LFP to hold at 56v, and its hard on the BMS and charge controller to cycle on and off. There needs to be a reasonabl...

@krzysiek_kta I don't want closed loop comms, I want to program voltage setpoints. This is working correctly finally on a 6000xp system that is offgri...

I had the same problem with the first 6000xp I installed.... and it was eventually resolved with a firmware update. I would have hoped the same logic ...

@eg4eric 6x Midnite Solar powerflo-5. I do NOT want to use closed loop comm cables, which is why I set parameters as shown in top post to enable the ...

Here is a picture.... voltage is floating at 56 instead of 54 as defined. I consider this to be a BUG, and not happy about it since holding batteries ...

@sullyman I think you need either: - a 48vDC power supply, or - 240vAC, or - 100+vDC into PV MPPT

what I am finding so far is that the timezone GMT setting will override the clock setting, so the only way to approximate what I want to see for "dail...

I have a related but different take on this. I have an offgrid install where I am more interested in setting system time up so that the reports consid...

@eg4eric , I went to the site today and did a little testing. Here are the results: - turned on PV input, unit remained dead - turned "power on" w...

I will check for battery terminal input failure later today. If something internal has shorted.... what is the fix, and can it be done in the field,...

@eg4eric there is no Grid at this site, and no generator yet. I do have the PV available, but I thought the batteries had to be connected first to pow...