@eric thanks

@sjvickerNo worries! I understand!If you do need any assistance setting the dongle up, feel free to reach out to me or contact us at support@eg4electr...

@dannybeardsley I believe adding a BMS would help the inverter more accurately read the battery voltage. It does appear that the inverter is having di...

That's very interesting—thank you for sharing! I also believe setting it to 100% should resolve the issue. There shouldn't be any problems increasing ...

It will not cause any damage. When I mentioned running by voltage, I was referring to using Lead Acid mode on the inverter. However, I haven’t heard o...

@eric , so is SS right when they say Do not run lithium mode by volts?? Will that damage the batteries or inverter? I know a few guys that need to kn...

47V is definitely not 0%, but it is considered below 20%. Voltage is a more accurate reading because the inverter measures it directly from the batter...

That was my thinking as well. If I push the reset button the default setting is 10%. I’ve been increasing this setting by 10% after the inverter goes ...

Not yet, but I'm working on creating a large battery box with 12 Tesla modules and will have a BMS then.

For the very first setting on screenshot (System Discharge Power rate(%)= 40%) Have you touched that at all?Can you change it to 100%, I believe this ...

@eric Sounds good, thank you sir. That is what I was thinking but wanted to make sure nothing broke. Thanks again.

@nctarheel1980@jasonCan you both send me a private message with your dongle's serial number and also a screen shot of the Dongle connect Parameters as...

I’ve been in lead acid mode trying to deep cycle them so it doesn’t show them. I’ll get the BMS test done tonight and look at them. Phillip and I will...

Yes, charging by voltage in lead acid mode would be the best approach. I’ve attached a document that explains how to properly top balance the batterie...

@joel-brodeur I believe this is normal. Since the battery is already at 100%, it likely wouldn’t be considered charging. Instead, it’s more of a maint...