Do you have solar connected to it?Just to confirm, you said you don't have GEN boost enabled, correct?

@eg4eric version 1.5.4 I logged out, removed the app, rebooted the phone, reinstalled and logged in, same offline message. I'm using a Pixel 7 Pro...

So with the V2, I use the BMS Tools, not the BMS Test, and my RJ45 should be plugged into Battery Comm. I will give it a shot after changing battery ...

@thomaspugmail-com Great! If you have any other questions or run into any issues, feel free to reach out!

I see. I apologize for the confusion. I read BMS TEST so I assumed you were using the Lifepower4-V1.You will need to set the Master battery to ID #64 ...

Sorry for the double post.

@michaelahess Do you know which app version you are using? I'll look into this, but for now you can try this: Log out and log back into the app. (I...

The manual for the LifePower4 V2 batteries has this: which led me to believe that the host/master should be ID:1. Should I change my batteries t...

Is this the same with the LifePower4 V2 batteries with a six position DIP switch? The manual for these batteries has this: Which appears to say ...

Yes, that is correct. The only change you need to make is you would set the Master/Host (Battery #1) to ID:0 Battery #1 (Master/Host): ID: 0 Batt...

I recommend going with either option 7a or 8a. To ensure that no power is sent back to the grid, you’ll need to enable off-grid mode on the inverter. ...

Thanks, I did read that, but was unclear if battery #1 was ID:0 or ID:1. My DIP switches are like this: Do I make the Packs Number 3? I am us...

I completely understand where you're coming from, however at the moment, I don’t have a direct answer for you. What I can do is submit your feedback a...

For the master battery, you will want to start with Start Adr:0 Not sure if you've looked at the guide document but I'm attaching it in case you n...

Bump to make sure EG4 sees this (still no response)