got it running.... portable power in a 63gal toolbox: 10kwhr-eg4.3k 120v AC inlet for charging from grid PV input for charging from PV AC out ...

@joel-brodeur Have you tried enabling Generator Boost?@wardo5757 Understood! I'm trying to gather as much information as possible. Thank you for being...

@eric Is the battery type something you can remotely change? This inverter is very remote ...... I thought it was 0 for EG4 on the 6000xp and 1 for 12...

@somej I did notice the two working ones were sequential serial numbers and the third was not ... they were all purchased at the same time from my loc...

@eric think all three were listed at 55% SOC which seems standard for the new batteries I have been getting, 51.4 or something?

I apologize for any confusion, but I'm glad you were able to get it connected. If you run into any issues or need further assistance, please let me kn...

{solved} turns out that the paper manual v 1.3.0 was terrible, but the online v 1.3.2 is better, and I was able to get wi-fi monitoring working. ...

the battery BMS is trying to protect itself from over voltage. your setpoints are too high. read thru your battery manual carefully to see what recomm...

I can't see your photos either. I didn't know EG4 had a "certified installer" program, but I would definately go back to that installer and have them...

Eric ask me about my settings on that but I’ve never seen it. Is that only on the monitoring site? My is not on there.

@ron I would say both. Mine completes charge and switches to the batteries. You don’t notice anything. Then it switches back to Gen and after a per...

What I was trying to say is that while the inverter is being powered by the generator the inverter is converting AC/Gen to DC/battery charging and the...