@pawnee Glad the update fixed the Gen run, did it also fix the Watt readings? Hopefully @eric has some news or suggestions on the hard handover. J...

@mylesj I am guessing you can't disable it. Maybe just set your gen start SOC to something like 20%. Also, if you haven't already, you might try, r...

@joel-brodeur Hello Joel, I tried you suggestions and it did not work. I have tried to disable the generator setting and it wont allow me to do it...

@joel-brodeur Hello Joel, I tried you suggestions and it did not work. I have tried to disable the generator setting and it wont allow me to do i...

So getting the firmware completely pushed through got my generator running like it was before, but I’m still getting a browout/hard handover. Bad enou...

One other question - what firmware are you at? JB

@mylesj I notice that you have the Gen settings also set. Are you using a gen to charge as well? If not you might try disabling the gen charge setti...

@joel-brodeur Thank you Joel! I just tried your suggestion. Still nothing. I hit the quick charge button again and it says its charging but it is n...

From the "E G 4 ® 6 0 0 0 X P M O N I T O R S Y S T E M W O R K I N G M O D E S" on page 4. EG4®-6000XP-Monitoring-System-Working-Modes.pdf

Have you tried setting you AC charge times to - 00:00 to 23:59 JB

@eric any update on this. I am seeing a similar issue after bringing the nging my Gridboss and Flexboss21 online last night. The Gridboss does not sho...

@joel-brodeur It’s a Milbank 15K made by Briggs. It’s a bit different than most. It’s a two wire start but it must not see 240 volts to run. I have...

@pawnee Just curious @pawnee what gen do you have? JB