The Lifepower4 V2 must serve as the master battery due to the architecture of the BMS. This document will assist you in setting up communication betwe...

@jarrett , great, I'd appreciate that. What I am looking for is the ability to set inverter charge setpoints such that I get a proper CC/CV charge cur...

@joel-brodeur This is the expected behavior. However, I’ll forward this to our R&D team to explore potential improvements in the charging logic wh...

@pawnee I generally prefer using SOC for BMS communication with our batteries. I'd only switch to voltage to recalibrate SOC unless you find it perfor...

Let me pass that along to my director, and see if that is something we can do.

Thank you for sharing! Please don't hesitate to reach back out if you need any support in the future!

Thank you Mr. Baker, I will pass that information along to the R&D team, as well as the firmware engineers.

@treedor Wonder if it is a geographic issue. Everything is working at my location. App and website.

My thinking is that you can connect the Chargeverter to all batteries when connected in parallel via bus bar OR only one battery if they are run in pa...

@ron your questions are the same as mine. Hopefully jared will read and reply. I also need to know should I connect to primary battery with chargever...

@grissam-solar I used a bus bar since the Chargeverter comes with a ring terminal on one end and I didn't have the correct tools to put the amphenol c...

My system is One EG4 18k inverter with two All-weather pro outdoor wall mount Batteries. The system is hooked up to the grid also for charging the bat...

@joel-brodeur thanks. I’m going to contact Tec support and double check. I’ll make a post and see what EG4 says. I’d love to she a SOC vs Volts chart ...

@pawnee When I used FLA I too was told to never use SOC. However, with my old system I found that with proper bi-annual maintenance (re-torquing all ...