I have had remote updates fail and I was able to just re-run the process. However, I do not run parallel 6000xp's so my experience is with just a sin...

My 2-battery drift that way as well on SOC but definitely not that dramatically. I have seen posts on other forums about "resetting" the BMS's throu...

DOH Sorry but it is my best Homer Simpson imitation. 🙂 JB

Great catch. JB

Just out of curiosity, and I am sure you checked but, when you are checking voltage from L1 and L2 to Neutral, are you reading Vac or Vdc? The reaso...

@edo222 Nice looking setup! The wiring of the comms looks good. I have attached an image with an area circled. It appears that the comm wire has ...

Is that your battery discharge current? If so, and this is just a guess, if you are using closed loop to talk to the batteries, then I am guessing t...

Have you tried re-routing the comm cable, or maybe even a shielded cable (maybe it is getting some signal bleed from the power cables)? Also, if the...

From the spec sheet. Min 100V +- 10V for start up. Min operating 120V Hope this helps, JB

Good to know, I wasn't aware of the EPS side of it. Thanks, JB

Signature Solar has a video in which she shows crimping for a degsen connector: Solar DIY: Preparing Battery Cables for Solar Installation - YouTube...

It looks like the discrepancy in SOC is growing with every cycle. Any suggestion. My fear is that one battery gets so low that it goes into protect...

Funny thing (not) is both his supplier and my supplier both said that the cables needed for firmware updates HAD been supplied. Kinda depressing but...

In general, the answer is pretty simple. An inverter, some batteries, and some kind of transfer switch. The specifics get very complicated quickly...

In the App, upper right-hand corner, tap the "user icon" the "User Center" opens. Tap on Notifications. Option for SOC notifications as well as ...