@zeppelin I use the SOC notice, and it works great.

@jlankford That makes sense, but if the power goes out, he plugs into the transfer switch, there shouldn't be any power on the grid side at all, corre...

@jlankford I was just thinking that if it is an ATS and the EPS output was somehow feeding back onto the "Grid" connection then basically the inverter...

@mylesj A few questions for you: 1 - What kind of transfer switch do you have installed? 2 - The wires connected to the "Grid" breaker on the 600x...

@jlankford Your absolutely right. The lag on the LCD is not very far behind It should have been showing no AC voltage in a power outage. Now I am won...

@jlankford and @mylesj The 6000XP only shows one leg of the AC input and EPS output at a time. you can tap the enter button to cycle through the le...

@eric I had it set in APL before and it actually seemed worse. My next gen run should be in a couple of days, if I remember to, I will try it again. ...

@eric Yes I do as per Jared. Here are my current settings.

@eric I have both solar and batteries. This time of year, my solar doesn't do much so it is effectively battery. My batteries are 2 X Indoor Wallmo...

Never mind, I see you already have. I am not certain what the next step is. I really wish that battery manufacturers would list the BMS that is ass...

You might take a look at the following doc: EG4-6000XP-Battery-Compatibility-List.pdf JB

Could you provide pics of the wire connections inside the 1200XP? Thanks, JB

@jlankford It will. That is pretty much how mine runs since I have no grid.

@mylesj From what I have seen the EG4 chargeverter is a great solution:EG4 Chargeverter - GC | 48V 100A Battery Charger | Signature Solar BTW...

@mylesj Based on the audio, that sounds like a relay is switching something. Maybe some setting conflict but I don't see which it is. I would sugges...