One other question - what firmware are you at? JB

@mylesj I notice that you have the Gen settings also set. Are you using a gen to charge as well? If not you might try disabling the gen charge setti...

@joel-brodeur Thank you Joel! I just tried your suggestion. Still nothing. I hit the quick charge button again and it says its charging but it is n...

From the "E G 4 ® 6 0 0 0 X P M O N I T O R S Y S T E M W O R K I N G M O D E S" on page 4. EG4®-6000XP-Monitoring-System-Working-Modes.pdf

Have you tried setting you AC charge times to - 00:00 to 23:59 JB

@eric any update on this. I am seeing a similar issue after bringing the nging my Gridboss and Flexboss21 online last night. The Gridboss does not sho...

@joel-brodeur It’s a Milbank 15K made by Briggs. It’s a bit different than most. It’s a two wire start but it must not see 240 volts to run. I have...

@pawnee Just curious @pawnee what gen do you have? JB

@eric yes I have it and will update on Monday when the family is not around

@eric my generator will run today and I’ll see if the new firmware makes the handoff better. Joel described it perfectly above. Brownout is a good ...

I updated the 3 eg4 LL S to the mulitpack firmware version went from Z02T18 (factory version) to Z02T12i changed each of the battery to use the P06-Lu...