@jared Just realized I had this photo on my phone. Shows the dip switch configuration:Battery 1- - - - - -Battery 2 -- - - - - Battery 3--...

I have read every thread I can find on the Grid & Flex Boss's as well as Googled & watched every YT video I can find including the 2 interview...

@dfwtinker Yay! You made through the first one. My place is in the mountains of Montana, I wonder if I wrap that tape and spay foam a box around the ...

So after four hours of wanting to put .45" holes in this inverter I finally got it updated. I found you can only update by making the dongle on the un...

So overnight we had our first freeze. Here in North Central Texas that does not usually last long, but long enough to crack pump casings and such. ...

I give up. I was trying to make a youtube series reviewing this inverter. I will let everyone know it failed. I tried my best.

App wont show an update. Dongle will not connect to a wifi signal I provided. I literally stuck a wifi router five feet from it. I have de-googled and...

@bobandroslyn Good information. 🙂

@chrisneibauer To perform a remote firmware update the inverter itself needs to be connected to the internet. Otherwise, it will need to be updated "...

And, for reference, here's that video by Wipp Prowse

@jared I can, in a week, when I'm back up there. However, they're all connected to the bus bars in the EG4 cabinet, using the supplied cables--the bus...

Thank you for sharing that information. Seems to confirm storing SOC , but no issue discharging below 20% as long as it is recharged back. No warr...

OK so I ran 300ft of ethernet cable down to the inverter with an internet connection to the laptop to try and connect via the dongle to no avail. It w...