@powerup yup that would handle my situation, charging up to 56 volts and then discharging down to 50% SOC. Basically some way to get the battery compl...

@powerup I'm not sure I would need that so long as the top SOC could be set to 101%. I think I just want to set the battery charge/discharge based on ...

Now able to sign in and checked that it's now working as an 18KPV. Thanks for your attention.

@david271 I have a request to allow Charge/Discharge to be set independently to Volt / SOC. DO you think that could offer the capability needed? To...

I prefer to minimize generator use for off-grid clients and have it kick in only when needed, bump up the voltage "a little" and repeat if needed for ...

watts coming in will drop to near zero when batts are full and there is no load during the afternoons when PV power is available.   LFP cells...

Now it's giving me - Too many login attempts. I'll try again later.

Eric, Having an issue getting into my account. Was not able to get into my inverter monitor account initially. Seemed that my original password would ...

Forgot to attached the picure

@fkitzmann That could be possible!I went ahead and made the change, and it looks like it's working properly. Let me know if you have any issues.

@david271 I'm not sure. I haven't tested. I just noted that I can set the AC charge SOC to 101 as well as the battery but only if I'm using the same s...

@mccorb hmmm, I'm not going to upgrade the inverter firmware right away, but I will check for sure when I do. But you say that even AC charging up to ...

FYI - It may have got changed when I did the last update. Possibly with EAAB-2525 or IAAB-1600