@cnmmikeYou can change the start to 100 and the end to 255, this will allow the inverter to use AC coupled system all the time. This should help with ...

@powerup Again we apologize for the inconvenience! Thank you for sharing! We will look into this, but other than that, if you run into any other issue...

Thank you for the information. I appreciate it!  

TWELVE DAYS UNTIL DST I was wrong earlier when I mentioned the correct date is March-8 It would be proper to tell us now if Engineering thinks it ...

@eg4eric Thank you, this solved the client issue. We installed and have tested. Forum members should know that it can take 15+ minutes for battery fir...

@eg4eric Thank you, this solved the client issue. We installed and have tested. Forum members should know that it can take 15+ minutes for battery fir...

@eg4eric Thank you, this solved the client issue. We installed and have tested. Forum members should know that it can take 15+ minutes to register (in...

@eg4eric This solved the client issue. We installed and have tested. Forum members should know that it can take 15+ minutes to register (in our case w...

@eg4eric Start 70% SOC, end 100% SOC

@mtjag Yes, you would need to set the Charge start Voltage setting. Once the battery goes lower that the set parameter, the generator will begin to ...

@cnmmike What are the parameters that you have set up for AC Couple?

@energybalanced Yes, it is!

@thismainething I will share these too options with our team for future consideration.

@powelljn50 Because your batteries are communicating with the inverter already, there is no need for the communication cable between batteries and cha...

@wade13x Are you having issues with your dongle?