Hmm. Actually, this is worse than originally stated. I'm not sure what is wrong with the downloaded file, but here are the steps you can follow to ...

No solar yet (it is trickling in thru an old PWM controller, OCV is too low to use the 6000, we need to add another panel there) Gen Boost is NOT en...

Do you have solar connected to it?Just to confirm, you said you don't have GEN boost enabled, correct?

@eg4eric version 1.5.4 I logged out, removed the app, rebooted the phone, reinstalled and logged in, same offline message. I'm using a Pixel 7 Pro...

So with the V2, I use the BMS Tools, not the BMS Test, and my RJ45 should be plugged into Battery Comm. I will give it a shot after changing battery ...

@thomaspugmail-com Great! If you have any other questions or run into any issues, feel free to reach out!

I see. I apologize for the confusion. I read BMS TEST so I assumed you were using the Lifepower4-V1.You will need to set the Master battery to ID #64 ...

Sorry for the double post.

@michaelahess Do you know which app version you are using? I'll look into this, but for now you can try this: Log out and log back into the app. (I...

The manual for the LifePower4 V2 batteries has this: which led me to believe that the host/master should be ID:1. Should I change my batteries t...

Is this the same with the LifePower4 V2 batteries with a six position DIP switch? The manual for these batteries has this: Which appears to say ...

Yes, that is correct. The only change you need to make is you would set the Master/Host (Battery #1) to ID:0 Battery #1 (Master/Host): ID: 0 Batt...

I recommend going with either option 7a or 8a. To ensure that no power is sent back to the grid, you’ll need to enable off-grid mode on the inverter. ...

Thanks, I did read that, but was unclear if battery #1 was ID:0 or ID:1. My DIP switches are like this: Do I make the Packs Number 3? I am us...