Are you able to run quick charge again so we can monitor the system while the charging is happening, and we can look at the settings to see what exact...

I was able to look at your settings and it looks like you have the Charge Last setting enabled. This would cause the inverter to sell back to grid and...

You would connect the CTs on Line 1 and Line 2 between your meter and service panel with the arrows pointing towards the inverter and you would plug i...

Also note, the issue is recurring.

See attached notes...

Call Signature Solar and they will help you out

One last question. In self-consumption mode with solar, when there is excess power generated and the battery is full - does the extra go to the utilit...

@eric So this would be using Force Discharge instead of Peak Shaving?

I might have it. I had a mode DIABLED but had left the time set from 00:00 to 22:00. When I set both too 00:00 self consumption started.

The parallel setting was an issue, I had found the 'sync inverter' button that fixed the displays. I assumed it only applied with multiple inverters b...

It appears the system is already set up in parallel.Also, make sure that the battery backup mode isn’t conflicting with any discharge settings.

Also, make sure that none of your charging parameters conflict with your discharging parameters.

Have you tried setting up the Force Discharge and still having Battery Backup Enabled?This should force the batteries to discharge at a certain time o...