Sorry, I don’t think there is a way to connect CTs when there is a busbar between meter and panel. essentially no wires to measure incoming current ...

I seem to be up again after trying the update several times but the current update hasn't cleared or refreshed and this has happened several times, it...

I had my mini split RMA replaced (outdoor unit only) . I had the same concern with pre-charged line set. Therefore I talked with the vendor and made t...

Hi Solar Pergola thanks for reaching out. The load breaker will accommodate up to 1/0. And the grid terminals will also and N busbar. Although the ...

@eg4eric I don't have a generator connected to GridBoss. There's no circuit breaker on the Generator input

I have the EG4 14.3 kWh Power Pro. EG4 has been very good at responding to my issue. It took a few days (less if you consider business days 🙂 ) to g...

@fkitzmann Agree on that last suggestion. Also I'm looking into getting an Ethernet dongle as backup, I just can't find one in stock ATM. The WIFI sig...

@dougkellis. Hi Doug, i also have a battery that seems dead. Mine is an EG4 all weather 280A wall mount and i also need to get a new one in warranty s...

@eg4eric I finally got the dongle to connect w the home wifi,,,,, BUT, now I cannot "add device" to my pre-existing SmartESS account. I had installe...

So, i had the Chargeverter again on 1 Amps from 2 hours, then 4 hours with 5 Amps. I had to stop because of the rain but in a nutshell, i had the char...

That worked for me as well. 😀 Had reinstalled ap with no luck. Shutting everything down for 10 minutes did the trick. Thank you so much fo...