@eg4eric - Thanks for helping out. I haven't seen any failures in a few weeks. That being said, I don't really know what fixed it. I think I may have ...

Ok I've installed both the latest rs485 and rs232 firmware on all 6 batteries.   Keep in mind that I did this process a month or so ago and d...

Whatever routine is configured to stop charging if communication is lost is a bit too sensitive IMO! (Why is it losing communication in the first plac...

I had installed the latest, the issue still persisted. Reminder that i had 4 batteries, then added 2 more ~6months after the initial install. This is ...

Found it in the zip file

where is the changelog?

The only thing i notice thats different on the data logging is that the BATSTAT goes to 2 vs 3 when it goes into these ~10 minute periods of not worki...

Well, it happened today. battery charging stopped for 10 minutes almost exactly at 11am. This time it recovered by itself without any intervention. wh...

Check: Batteries have latest firmware for both rs232 and rs485. No issues since I swapped the battery comms from the slave inverter to the master inve...

Ok new weird stuff happened today: At 1038 it goes into pv batt/ac charge mode without any input from me.Then at 11:03 it goes into that same PV O...

@eg4eric   Wait... I had it set to Option 0 for standard.   But you are saying it should be set to Option 1 HinaESS? Why is it not c...

The inverters are set to LITHIUM 0 (these are 12000xps, there isnt an option for eg4)The batteries are set to EG4/Lux@eg4eric I checked every battery....

On second look, This appears to be a battery communication issue. Any ideas as to what is causing that? It appears to happen when PV is really chargin...

I do notice that the Batt Status goes to "2". unsure of why the batteries are affected by it swapping over.