@thomaspugmail-com Not at the moment, but as soon as we do, it will be posted on our website. I know that the LCD V18 firmware adds the Gridboss optio...

I understand and I'm happy to help! (We do have a guide that explains the website.)EG4-Monitor-Center-Overview.pdfI just need either your inverter's s...

I'm glad you were able to figure it out and I apologize for any confusion or inconvenience this may have caused. Thank you for the feedback. I’ll pass...

Since the 6000XP is an off-grid inverter, it primarily depends on PV and battery sources to power loads. However, you can configure the settings to al...

As you mentioned, this configuration is not recommended as these batteries were not made to work together in series. To ensure system stability and av...

Do the batteries have 4 DIP switches? I've attached a document that shows how to tell the difference between the 6-DIP and the 4-DIP switch batteries....

Understood!If you provide your station name or serial number, I can update the LCD firmware remotely on my end.

Yes, 100% should be around 56.2V. You can temporarily switch the inverter to Lead Acid mode and set the Charge Voltage to 56.2V, the Float voltage to ...

@thomaspugmail-com After further investigation, I was able to find that you should be able to update the LCD remotely through the monitoring website a...

@simply-efficient If you have one or more inverters connected in parallel, make sure they are all set to standby. If you’d like, you can send me the s...

@thomaspugmail-com The LCD V18 will fix this issue. EG4® 12kPV All-In-One Hybrid Inverter - EG4 Electronics

This issue may be caused by a loose connection. I recommend double-checking all battery cables to ensure none are loose. Have you also tested the batt...

Make sure that you have a specific network for 2.4GHz and don't have any special characters in the Wi-Fi password.

That should be correct for the 12kPV. You shouldn't have any issues. However, If you run into any issues with the inverter, feel free to reach out. We...

Hello @tlane17, exactly what you need help with? I’ll do my best to assist you!