EG4 Community Forum

jxnhrpr
@jxnhrpr
Eminent Member
Joined: July 5, 2025 4:01 am
Last seen: September 15, 2026 3:22 pm
Topics: 4 / Replies: 14
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@eg4eric I visited my remote site two days ago and followed the steps recommended by Signature Solar. The batteries restarted with the correct addre...

2 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@eg4eric I attached the only photos I have handy of my battery-inverter connections, but I don't think they will help much. Pretty conventional stu...

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@eg4eric Yes, I tried to reset them to ID=1 and ID=2, but I think the steps I followed weren't quite correct. I was getting 0V at the inverter's BA...

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@frugal-farmer. My EG4 batteries usually communicate fine with my EG4 6000XP inverter, and I have been operating in closed-loop communications mode. I...

3 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@dtbaker61 I'm pleased you were able to update with no issues. They don't make it simple. I've read/viewed every scrap of information I can find on...

9 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@eg4eric I stumbled on the following YouTube video describing installation and set up of a Luxpower SNA 6K inverter, which is a close relative to t...

9 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@dtbaker61 Thanks for your interest, but it's a bit more complicated. My existing 6000XP installed 500 miles from home at a location with no availa...

9 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@eg4eric Thanks. That would be very helpful.

10 months ago
Forum
Reply
RE: 6000XP AFCI & GFDI Implementation

@eg4eric Or did you mean the PV input will turn off and the EPS output will turn off, but the inverter box will not turn off?

10 months ago
Forum
Reply
RE: 6000XP AFCI & GFDI Implementation

@eg4eric Your comment the inverter will not shut down is counter to the 0/03/2025 at DIYSolarForum.org, where a 6000XP user stated. "In three month...

10 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@eg4eric I thought a non-panel DC source might be possible because the EG4 Monitoring application has a PV Input Mode option of "0:DC Source". What...

10 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@eg4eric Could that PV input be some type of benchtop power supply, rather than solar modules that I don't have at home.

10 months ago
Forum
Reply
RE: Update/Downdate 6000XP Firmware at Remote Location

@eg4eric In response to my original inquiry, you said, "As of now, the only way to downgrade the firmware is to do it manually through the EG4 Moni...

10 months ago
Forum
Topic
Replies: 3
Views: 1059
Page 1 / 2