@we2 Yeah, that is kind of what I was looking at, utilizing the 18kpv w/PowerPro’s as the primary(load connected to main panel) and have the 6k’s and ...

@eric That is kind of what I figured.

@jared Thanks for your reply. I have a quick question regarding the new EG4 LL‑S 48V 100Ah batteries. If I set up two PowerPro indoor batteries (280A...

@frugal-farmer I am not sure if the inverter rebooted or what. It shut down all loads for a few seconds seemed to be about 5 to 10 seconds si I am gue...

Is it possible to program that inverter to not go into bypass mode when fully charged or slightly loaded? Curious minds wish to know!

Please elaborate on "shuts down". Are you saying it turned itself completely off momentarily? I don't have the 6000XP but instead 2 3000's and when t...

@headybrIf you provide your inverter's serial number, we can reset it for you.

@eric I am trying to get BMS tools going. Got a new adapter for my laptop and gonna try logging in this afternoon to his battery. It just says Protect...

@Eric Aloha Eric, I was able to go to site and change it. Waiting for results, crossing fingers! Thank you

42 is the max that setting #11 allows me to enter. It says cut off, rather than eod. Is this the same thing?

@eric The battery screen doesn't light up at all. Neither do the bars indicating charge.

@scottmr808 For the WallMount batteries, the Lithium type will be 1 for all the inverters. I did see that you were able to change it. Has your client ...

@scottmr808 Where are you seeing this protection mode? Are you using BMS Tools?