EG4 Community Forum

Anonymous
Joined: May 7, 2026 9:42 am
Topics: 7 / Replies: 19
Reply
RE: EG4 14.3kWh indoor wall mount battery BMS comms issues - resulting in blackouts, power blips, and charging restarts

A positive update, Today I decided to look again at my setup and search for any more error logs in addition to what I have already reported. I...

6 months ago
Forum
Reply
RE: Sequence of operation for modes

Thanks for the reply. That was helpful, but I was hoping for more sequence information. At the moment, I'm trying to do a simple switch from Solar/B...

6 months ago
Forum
Reply
6 months ago
Forum
Reply
RE: one of two new 12000xp delivered DEAD ?! what's next ?

@eg4eric , I went to the site today and did a little testing. Here are the results: - turned on PV input, unit remained dead - turned "power on" w...

6 months ago
Forum
Reply
RE: 12000XP and Ruixu Lithi 2-16

Is there any timeline to provide support? I noticed that the configuration which works (BYD #12) isn't on the screenshot you just shared either.

6 months ago
Reply
RE: Newbie Help, Missing Battery information on Monitor Center

I have two Wallmount AllWeather batteries and the battery parameters never showed up for me. I had lithium brand set to 0:EG4. Changed to 1 bec...

6 months ago
Forum
Reply
RE: 18kpv/powerpro charging issue

What settings do you have configured for the Generator battery charge current; the Charge SOC/Voltage Start and Stop?If you provide me with your inver...

6 months ago
Reply
RE: LiFePo04 v2 Serial number

@diver-dave I apologize you didn't get a response, did you still need assistance?

6 months ago
Forum
Reply
RE: one of two new 12000xp delivered DEAD ?! what's next ?

It would require an RMA and have it replaced.

6 months ago
Forum
Reply
RE: 12000XP and Ruixu Lithi 2-16

@billmag Understood!Because Ruixu batteries aren’t on the compatibility list for the 6000XP which is the same for the 12000XP, it can be a bit difficu...

6 months ago
Page 103 / 392