For consideration: Flex-boss 21 would be better served if it had a way to start a generator or manage multiple chargeverters in an off grid scenario, ...

@eg4eric I have batteries paralleled and communicating. The RG485 is connected to the 1st chargeverter annd master battery. It is set to start gene...

I have the same problem. My home theatre receiver and subwoofer both have humming transformers (not through the audio signal, but physically). It ha...

@caesarv that's pretty much my take on it too. The old/current app shows you pretty much all the data with the exception of accumulating ac-coupling ...

I wish I had seen this post prior to updating my batteries... Same issue as described. I upgraded both RS485 and RS232 firmwares to Z02T28 & S02T2...

@cshurtz the EG4 suggestion(s) was to revert to lead-acid mode (not an option for our client). it is unclear if that helps to see the data for all bat...

@samjam24x7 Can you share a screenshot of what you're seeing?I would like to confirm it's not the app. If it's an issue with the app, sending another ...

@bobandroslyn I don't believe it's supposed to provide a confirmation, but it would be a good idea for them to send one. I will mention this as well. ...

@gigadude I would have to double check if we can send a replacement board or if the whole inverter would need to be replaced. Have you tested voltage ...

Why don't you just remove the wifi config (SSID and passkey),from the donglemso you are sure it cannot connect to wifi? I'd rather be sure as opposed ...