It’s best to evenly distribute the arrays across all inverters connected in parallel.

If you provide your inverter's serial number, I can go ahead and get that cleared for you.

@eg4eric thanks for the response. I did install them correctly, but what is required for the CTs to report consumption is that you also have the AC wi...

You can make your own wires; however, if that’s not something you’re able to do right now, we can continue troubleshooting and revisit this step later...

When you installed the CT's, did you install them with the arrows pointing towards the inverter?

Good morning! You will need to change the time and set the correct time zone in the following: Configuration > Station > Station Management ...

Hello anyone there

@JanvozenilekWe apologize for the delay in responding to your email. Due to a higher-than-usual volume of inquiries, our response times have been slig...

As a follow up on this.....I would like to point out that it "may" be possible to use other inverters (not just EG4) with the Gridboss. The gene...

Try the DIY Solar Forum if you can't get any help here or via email. removed link