How many batteries do you have in total? Also, how do you have the batteries connected? Are you using bus bars?

You’ll need at least 140V for the MPPTs to begin operating and charging the batteries. Do you know if the voltage has gone above that threshold and ...

Unfortunately, the 12kPV wasn't designed to have the breakers replaced with smaller ones. You can limit the amount of current used from the generator ...

I have the same issue with the correct time not sticking with my GridBoss, firmware version IAAB-1300

Hmm. Actually, this is worse than originally stated. I'm not sure what is wrong with the downloaded file, but here are the steps you can follow to ...

No solar yet (it is trickling in thru an old PWM controller, OCV is too low to use the 6000, we need to add another panel there) Gen Boost is NOT en...

Do you have solar connected to it?Just to confirm, you said you don't have GEN boost enabled, correct?

@eg4eric version 1.5.4 I logged out, removed the app, rebooted the phone, reinstalled and logged in, same offline message. I'm using a Pixel 7 Pro...

So with the V2, I use the BMS Tools, not the BMS Test, and my RJ45 should be plugged into Battery Comm. I will give it a shot after changing battery ...

@thomaspugmail-com Great! If you have any other questions or run into any issues, feel free to reach out!

I see. I apologize for the confusion. I read BMS TEST so I assumed you were using the Lifepower4-V1.You will need to set the Master battery to ID #64 ...

Sorry for the double post.

@michaelahess Do you know which app version you are using? I'll look into this, but for now you can try this: Log out and log back into the app. (I...

The manual for the LifePower4 V2 batteries has this: which led me to believe that the host/master should be ID:1. Should I change my batteries t...