I do not see anything both on the web as well as the app.. it was working fine few days ago.. here is the screen shot...

@rick151You can try setting the inverter to Battery Type: Lithium and Lithium Type: 2 (Pylon Protocol)

@sgazulaCan you share a screenshot of what you see?Are you using a computer?Everything is working normal and there should be no issues.

@eg4eric Could that PV input be some type of benchtop power supply, rather than solar modules that I don't have at home.

@jxnhrpr As long as the inverter has at least one power source, the firmware will install. However, if PV is not connected to the inverter, the MPPT p...

I had the same issue, but it begs the question: Why would you NOT set the battery type to EG4 rather than "1"? They are EG4 batteries. I have wasted a...

@mtjag Do you know what the voltage was on the batteries when the inverter shut down?

Hi, I am unable to see anything on the monitoring site for my system still.. do I need to do something here? thanks

@cgrecoWe would need to know exactly what loads were on, to figure out if it was truly pulling 12kW to the load.

@yooperjay mmmmmm, this is not generator transfer related in this case either as there isn't one hooked up. This blink occurs when charging by regular...

@dtbaker61 got it. Well I guess that setting won't help then ... I am totally off grid for sure no AC grid ... only generator/solar. Confusing (to...

@yooperjay Nope, your setup is not similar.... you have AC in, and my client is off-grid (NO ACin).   The problem she is reporting cannot hav...

@dtbaker61 ... I have very similar setup with 6000xp and 2 280Ah indoor batteries. I have noticed this problem as well ... I changed this setting via...