EG4 Community Forum

Ravasunpower
@ravasunpower
Active Member
Joined: May 5, 2025 2:20 pm
Last seen: May 29, 2025 8:50 pm
Topics: 2 / Replies: 13
Reply
RE: Error code 25, 27 on XP6000

Eric, i did install the spare i had bought with the other one and all is working now apart from not going to charge fully. I have done a lead acid cha...

2 weeks ago
Forum
Reply
RE: XP 6000 keeps shutting down…

Yesterday, It was doing the “usual”: stopping with a warning 25 and then restarting a few minutes later. Then i noticed that PV1 was ...

3 weeks ago
Reply
RE: XP 6000 keeps shutting down…

I am confusing posts and messages , i think… anyway, if you have not read the other message, i changed the inverter and all is well EXCEPT the dispari...

3 weeks ago
Reply
RE: XP 6000 keeps shutting down…

But thanks for your input, i will contact Eric again. He said he would connect to my system and check but i have not heard from him and i do not know ...

3 weeks ago
Reply
RE: XP 6000 keeps shutting down…

When it happens, it definitely says warning 25 with a flat face. it also restarts without my input. I did a few shut downs and restarts: when it re...

3 weeks ago
Reply
RE: XP 6000 keeps shutting down…

@joel-brodeur . Thanks… it has been on and off for the last 3 hours. The inverter shows the green flashing warning with #25 and i thought this meant a...

3 weeks ago
Topic
Replies: 10
Views: 18
Reply
RE: Error code 25, 27 on XP6000

Eric, i have to leave the house for a few hours. I am leaving the generator on the internet system so you should have access even if the system goes d...

4 weeks ago
Forum
Reply
RE: Error code 25, 27 on XP6000

I also noticed that on the monitor page, under the battery it was indicating “BMS charge Forbidden”. Now it is allowed…

4 weeks ago
Forum
Reply
RE: Error code 25, 27 on XP6000

System just went down again. I have the internet on the generator.

4 weeks ago
Forum
Reply
RE: Error code 25, 27 on XP6000

Eric, i just stopped the gen as the system came back online… it seems to come back when the first light comes on… coincidence?

4 weeks ago
Forum
Reply
RE: Error code 25, 27 on XP6000

Good morning Eric, the system went down again during the night. Warning 25 again. I borrowed a generator but it is not on the system directly: i just ...

4 weeks ago
Forum
Reply
RE: Error code 25, 27 on XP6000

@eric i went into the monitor.eg4electronics.com and i am a bit overwhelmed… so, yes, i would really appreciate if you could change the parameters ...

4 weeks ago
Forum
Reply
RE: Error code 25, 27 on XP6000

Thank you Eric for the fast answer! i just checked all connections, which were tight. Batteries with multitester indicate the same as the monitor an...

4 weeks ago
Forum
Topic
Forum
Replies: 12
Views: 66