@cptmorgemaker We just tested this and it is working perfectly. If you are having issues, it could be happening only with certain settings set. Can yo...

@eg4eric I had a licensed electrician do the wiring between the main panel and the inverters, I did the wiring to the panels and cabled the batteries ...

@gigadude I am going to get with our team about this and show them the wiring diagram. I will let you know if we need anything else.

One common cause for confusion with this is that if your BMS transitions from blocking charging to allowing charging, the EG4 will show that charging ...

Another alternative to the Netgear switch is the LINOVISION POE++  

Multi-Camera Security Equipment & Configuration; I have been asked by another forum member to post information about the equipment I am using fo...

@wardo5757 Do you know if this fixed the 50/60 Hz issue? My inverter was being forced into 50Hx when my generator warms up, and it does not switch ba...

@eg4eric I think this topic was mistakenly marked "solved", I still need help getting my inverter fixed. Was the circuit diagram I sent sufficient or ...

Just an update on this issue: With the last firmware update ceaa-0709 Generator Switching is fixed. Switching from batteries to gen power is seamles...

@eg4eric Thanks Eric! Also- just tested the gen switching- Folk, they fixed it! It’s not perfect but it’s good. There’s still a hiccup when swit...

  From the Monitor website. "It is for absolute zero-export, when there is an AC connection. When enabled, the battery discharges power to lo...

@andymadridI apologize for the bad experience you are having with the app. If you would like, I can create a use account for you. I would jsut need th...

@mattcrumIf you have Off Grid Mode enabled, the loads will show as EPS. If you have Off Grid Mode disabled, the loads will show as consumption.

@eg4eric was the diagram sufficient? I need to get my bad inverter up and running again, I've been hitting overload shutdowns with my water heater due...