Installed the firmware update today. Did it through the web monitor and ran into a little glitch. It appeared to have run the first step (xx0Exx) th...

What is the F20 error?

Certainly, spikes above the limit that I've set drive it into bypass mode. But once the spike has subsided (currents well below the discharge limit), ...

@dannybeardsley the reason your inverter is pulling from the grid is because your amps are way too low on the Discharge setting. That’s your battery ...

@philip14505 I think you are logically correct in your approach to have three 30A breakers so that you can add the second and third inverter as well a...

@joel-brodeur It would, i can’t believe its not an option to set a SOC for solar charging, seems so basic to me, but then I’m very new to solar.

@wardo5757 That would be so nice.

@eric OK, you’re talking about A/C Charging correct? I was hoping you meant Solar charging.

No sir, you shouldn't encounter any issues, as this firmware update is designed to affect only the inverter and not the batteries.

@wardo5757 You can configure AC charging based on the SOC. Set the AC charge start percentage to the desired level at which you want the batteries to ...

@eric Sounds great sir. I will try to update my system over the next day or so but before I do I have a question regarding the update as it pertains ...