so.... does xxx709 include a fix for setting a "correct" charge curve for open-loop (no comms) Lithium ? i.e. user defined end-of-charge and float vol...

ping. @eg4eric , any word on target date for release of an update to address the "no float" bug with the 12000xp open loop charging?

@mtjag exactly.... by setting vBulk to 56.4, or 57, or even 58.0 give the BMS 5-10 minutes to balance at low current, and then allows a drop to vFloat...

@pawnee I'll report this issue to our team so we can look into it. Just to make sure you are using the EG4 monitoring app not the new EG4 connect app,...

  Yes, I’ve done it multiple times on my 18k’s just won’t work on the 12 or 6xp. Pretty sure it’s a App problem  

@eg4eric I have the same issue I Grid Boss and Flexboss21 to a new wall battery and generator plug- added to my Solar Edge PV system. But never see t...

Hey, moving the V2(no dip switches) to the master battery position worked like a charm: 9 batteries/900 amps shown! However, in an interesting twist...

I just installed a very similar architecture. I have a 400 amp split SE with two 200A breakers immediately after the meter, all combined in the SE pan...

@dtbaker61 I definitely don't want 3 or 4 hours at that voltage to be sure. I've spoken with the SimpliPHI tech over the past 4 years with these batt...

@ouijifour thank you for sharing. I'll start reading to try to figure it out. Strangely, today after switching my settings back to FLA lead acid, my...

@dtbaker61 That cycling from float to bulk back to float is exactly why I quit using the eg4 xp6000 for charging lithium batteries. There are a lot be...