Try putting the new V2 batteries without DIP switches as the master and the #2 battery. Then set the V2 with DIP switches and then the Lifepower4-V1. ...

I solved the problem. The Solar Assistant software was out of date. Updating the Raspberry Pi fixed it. FYI The RS485 is the top middle RJ45 labeled C...

@eg4eric More testing is needed. Anecdotally changing the Seamless EPS doesnt seem to make a difference. I'll do more testing. I wonder if there's...

@dannybeardsley , *most* LFP battery internal BMS will low-voltage alarm and protect themselves at 44 v. I would suggest you set your inverter LV cu...

Only if you think that there is a hardware issue with mine or a new version of software. Thanks.

@eg4eric Thank you for suggesting this. Do you happen to have a link to instructions on how I should do that? I am assuming you are talking about the ...

@natwall1 I would recommend updating the firmware! Most of the time the firmware update resolves this issue, other than that the settings look good an...

@crwsUnderstood! There was an issue with the Monitoring site reporting the wrong information. However, that only effected the RS485 firmware.

I don't like the new Connect app, so I am using the older monitor app on my Android phone. Using this, I occasionally get an 'Unknown Error' message....