@nickIt is available now through OTA. however, I will need to update your inverter first so that we can update the battery through OTA. If you send me...

Try putting the new V2 batteries without DIP switches as the master and the #2 battery. Then set the V2 with DIP switches and then the Lifepower4-V1. ...

I solved the problem. The Solar Assistant software was out of date. Updating the Raspberry Pi fixed it. FYI The RS485 is the top middle RJ45 labeled C...

@eg4eric More testing is needed. Anecdotally changing the Seamless EPS doesnt seem to make a difference. I'll do more testing. I wonder if there's...

@dannybeardsley , *most* LFP battery internal BMS will low-voltage alarm and protect themselves at 44 v. I would suggest you set your inverter LV cu...

Only if you think that there is a hardware issue with mine or a new version of software. Thanks.

@eg4eric Thank you for suggesting this. Do you happen to have a link to instructions on how I should do that? I am assuming you are talking about the ...

@natwall1 I would recommend updating the firmware! Most of the time the firmware update resolves this issue, other than that the settings look good an...

@crwsUnderstood! There was an issue with the Monitoring site reporting the wrong information. However, that only effected the RS485 firmware.