@eric thanks, all updated. much better. most of the numbers sync up. The enphase enlighten numbers still are a bit goofy, but that's nothing to do wit...

@eric Yes, Please go ahead and make the adjustments now that the system appears to be stable. Thank You!

@eric This is where we started: It is Now! 🙂 Yesterday morning while I was on the phone with Joe Murillo he mentioned that you had suggested...

@jared any news? I have one older indoor wall battery with the Z02T01 BMS and also 2 newer indoor wall batteries with Z02T03 BMS version. I would li...

Doesn't make any sense to me. Good luck

@ron amp clamp on the wires coming from the generator

@pawnee How exactly did you determine that the house loads were being powered through the batteries and inverter and not the generator?

LED lights are very sensitive to voltage especially on a dimmer switch. You may or may not have a wiring problem. My led lights do the same on dim. Pu...

Messaged you privately. Thank you!

Thank you, Eric! I looked at the video and I am confused about the Batt Setup screen. I have three batteries and the video has only one battery. EG...

@ron according to my 18k screen and my amp meter the generator is not running the house at this point. The batteries are when the brownout occurs, or ...

I don't believe this is a firmware issue. Significant flickering is typically related to wiring problems. I recommend checking that the neutral and gr...

Eg4 inverters were only made to work together with the same inverter model. You can AC couple an existing grid tied system into the 12kPV; AC coupling...

@eric Thank you. Do you know what controller would work with this configuration?